The steps below should be performed when the Movi is switched off.
Installing the Joystick SBUS Connector
Remove the Panel covering the SBUS port by removing the 2 x 1.5mm socket head screws
Plug in the Joystick SBUS Connector. Route the joystick wire along with existing wires.
Install the cover
Install the cover.
Please backup the current profile before making changes
Using the Freefly Movi App
Using the Freefly Configurator to setup the inputs for the Joystick
General Config
Remote Controller Config
Remote Operator Config
These changes are not required but for optimum response and performance you can use these settings.